Forum Title: Velux skylight stop limit on close
I have an old Velux (1998) which is now controlled by a WLC 100 (5204) unit which is the newer replacement. The issue I have since installation is the skylight and blind operate perfectly except for the close limit on the skylight. It just runs unless/until one hits the stop button on the wired keypad. I don't want to lose gears from excessive ratcheting - any suggestions?
Category: Windows & Doors Post By: Denis Ford (Raleigh, NC), 01/12/2019

Welcome to the forums. Once dried..... most glues aren't dissolvable. You may have to carefully drill out the screw.

- DIANE TORRES (Huntington Beach, CA), 02/19/2019

Refer to the following thread for a little more information.... particularly the part about the resistor in the motor unit.http://www.doityourself.com/forum/do...r-working.html

- TIFFANY WILLIS (Trenton, NJ), 03/03/2019

everything works correctly except on full close, the other thread I have reviewed but this issue is more like a lack of resistance so cutting out a resistor shouldn't be the issue, it started when I installed the updated controller a WLC 100.

- LESTER BARNETT (Oak Lawn, IL), 02/16/2019

Tips & Resources For Home Remodeling

requestaquote Get Free Quotes callnow 888-506-9527